Checking And Adjusting Brake Wire - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Checking and adjusting brake wire

Check that the brakes are correctly adjusted by
placing the rider on a slight downhill slope with the
clutch disengaged and activating the brake. If the
ride-on mower does not stand still, the brake needs
to be adjusted.
The brake is adjusted in the following way:
Rider 15V2
1. Remove the transmission cover.
2. Loosen the locking nuts (1).
3. Tension the cable using the adjuster screw (2)
until the play in the cable disappears.
4. Tighten the locking nuts (1).
5. The brake should be checked again after the
adjustment has been made.
6. Replace the transmission cover.
WARNING!
A badly adjusted brake can lead to
reduced braking capacity.
www.mymowerparts.com
Rider Pro 15 and Pro 18
1. Remove the transmission cover.
2. Unhook the spring (A) from the screw (B).
3. Check that the parking brake is not applied.
4. Set a clearance of 1 mm between the casing
and adjusting screw when pulling the casing.
Adjust with the nuts on the adjusting screws.
5. Do not tighten the nuts too hard to avoid
damaging the adjusting screws.
6. Replace the spring (A).
7. Check that the brake functions.
8. Replace the transmission cover.
Reparation instructions
A
B
33
English –