Removal/Installation Of Hydrostatic - Husqvarna Rider 18 ProFlex Workshop Manual

Reparation instructions
3
Rider 18 ProFlex
2
3
• Attach a washer and circlip onto the swing axle
(1).
• Refit the wire attachment plates and the
hydrostatic wire (2) and brake wires (3).
• Connect the belt onto the pulley and tightly screw
the tensioning wheel arm (5) onto the rear frame.
• Reconnect the tensioning roller spring (5).
3
Rider 20 ProFlex
5
• Attach a washer and circlip onto the swing axle
(1).
• Connect the wire to the differential lock, see
"Removal/installation of hydrostatic transmis-
sion".
• Connect the brake wire (2) to the brake arm.
Tighten the brake wire nuts.
• Reconnect the speed control ball joint (3) and fit
the locking clip. Secure the cable to the under-
side of the axle and clip the sensor cable (5) into
position.
• Fit the drive belt over the pulley and attach the
spring to the tensioning roller (4).
30
– English
4
1
Check that the controls and wires are correctly
adjusted (see "Checking and adjusting brake wire",
"Checking and adjusting speed control wire" and
"Checking and adjusting differential lock".
Refit the fan.
Finally, attach the transmission/gear box cover.
1