Husqvarna Rider 15V2 Workshop Manual page 10

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Maintenance
Lubricate choke control
Lubricate steering chain inside frame
tunnel
Check steering wires inside frame
tunnel
Clean engine cooling air intake
Clean the air filter's pre-filter (plastic foam)
1)
Change engine oil
Clean the air filter's cartridge
Check/adjust cutting height setting
Check/adjust parking brake
Inspect flame guard/spark arrestor
(optional equipment)
Change the engine's oil filter
(every 200 hours).
Replace the hydraulic oil filter
(every 200 hours) 4-5)
Clean/replace spark plugs
Replace fuel filter in pipe
Clean / replace pulse air filter
(Pro 15, Pro 18)
Clean the cooling fins
Check engine valve clearance
Check whether oil change
4-5)
change are necessary for gearbox
(every 500 hrs)
Replace the air filter's pre-filter (plastic foam)
Replace the air filter (paper filter)
(every 200 hours)
Carry out 300 hour service
1)
First change after 8 hours. When driving with a heavy load or when the ambient temperature is high, replace every 50 hours.
and replace the filter more often in dusty conditions.
4)
Conducted by authorised service workshop.
= Covered by this workshop manual.
= Not covered by this workshop manual or operating Instructions.
= Described in the operating Instructions.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cables are removed
from the plugs.
Page Daily main-
tenance
before after
-
-
29
-
-
29
2) (paper filter) -
51
33
-
-
71
-
-
62
-
4) -
4)
or filter
50
2) -
2)
-
4)
7
3)
For daily use of the machine lubrication should be conducted twice a week.
5)
Pro 18 only.
www.mymowerparts.com
Delivery and dealer service
Maintenance interval in
At least
3)
Weekly
hours
once a
main-
year
tenance
• The parking brake is applied.
• The cutting unit is disengaged.
25 50 100 300
2)
Clean
9
English –