Removal/Installation Of Hydrostatic Transmission - Husqvarna Rider 11 Workshop Manual

Removing/installation of hydrostatic
transmission Rider 13 H/13 H Bio and
Rider 16 H
1
• Block-up the machine in front of the rear frame
and remove the back wheels.
• Remove the transmission cover.
2
• Release the tensioning wheel spring (1) and
remove the tensioning wheel arm (2).
• Dettach the drive belt (3).
• Release the brake wire spring (4) and remove
the brake wire from the brake lever (5).
• Disconnect the hydrostatic transmission cable (6)
and the hydrostatic transmission switch cable
(7).
• Release the clamp (8) that holds the hydrostatic
transmission cable and lay the wire and cable to
one side.
• Release the disengaged clutch control spring (9).
3
Insert a garage jack under the hydrostatic transmis-
sion and loosen its five holder screws.
4
• Lower the garage jack and pull out the
hydrostatic transmission.
• Installation of the hydrostatic transmission is
carried out in the reverse hydrostatic transmis-
sion removing order
• After installation, check that the brake wire and
hydrostatic transmission wire are correctly
adjusted (see "Checking and adjusting brake
wire" and "Replacing hydrostatic transmission
wire, installation step 8"). Also check the oil level
in the hydrostatic transmission and refill as
necessary.
Reparation instructions
31
English –