Hitachi SJ700-2 Instruction Manual page 206

Coil No.
0035h LOG2 (logical operation result 2)
0036h LOG3 (logical operation result 3)
0037h LOG4 (logical operation result 4)
0038h LOG5 (logical operation result 5)
0039h LOG6 (logical operation result 6)
003Ah WAC (capacitor life warning)
003Bh WAF (cooling-fan speed drop)
003Ch FR (starting contact signal)
003Dh OHF (heat sink overheat warning)
003Eh LOC (low-current indication signal)
003Fh M01 (general output 1)
0040h M02 (general output 2)
0041h M03 (general output 3)
0042h M04 (general output 4)
0043h M05 (general output 5)
0044h M06 (general output 6)
0045h IRDY (inverter ready)
0046h FWR (forward rotation)
0047h RVR (reverse rotation)
0048h MJA (major failure)
0049h Data writing in progress
004Ah CRC error
004Bh Overrun
004Ch Framing error
004Dh Parity error
004Eh Sum check error
004Fh (reserved)
0050h WCO (window comparator O)
0051h WCO (window comparator OI)
0052h WCO (window comparator O2)
*1 Normally, this coil is turned on when the corresponding intelligent input terminal on the control circuit
terminal block is turned on or the coil itself is set to on. In this regard, the operation of the intelligent
input terminal has priority over the operation of the coil. If disconnection of the communication train
has disabled the master system from turning off the coil, turn the corresponding intelligent input
terminal on the control circuit block on and off. This operation turns off the coil.
*2 Communication error data is retained until an error reset command is input. (The data can be reset
during the inverter operation.)
Item R/W
Chapter 4 Explanation of Functions
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: ON, 0: OFF
R 1: Writing in progress, 0: Normal status
R 1: Error detected, 0: No error (*2)
R 1: Error detected, 0: No error (*2)
R 1: Error detected, 0: No error (*2)
R 1: Error detected, 0: No error (*2)
R 1: Error detected, 0: No error (*2)
R 1: ON, 0:FF
R 1: ON, 0:FF
R 1: ON, 0:FF
4 - 143
Setting