Hitachi SJ700-2 Instruction Manual page 125

4.2.60 Running signal (RUN)
While the inverter is operating, it outputs the running (RUN)
signal via an intelligent output terminal ([11] to [15]) or the alarm
relay terminal.
To use this signal function, assign function "00" (RUN) to one of the intelligent output terminals [11] to [15]
(C021 to C025) and the alarm relay terminal (C026).
The inverter outputs the RUN signal even while operating the DC brake. The following figure shows a
timing chart for the signal output:
Output frequency
FW
RUN
4.2.61 Frequency arrival signals (FA1, FA2, FA3, FA4, and FA5)
The inverter outputs a frequency-arrival signal when the inverter
output frequency reaches a set frequency.
When using the inverter for a lift, use the frequency-arrival signal as
a trigger to start braking. Use the over-torque signal as the trigger to
stop braking.
Assign the following functions to five of the intelligent output terminals
[11] to [15] (C021 to C025) and the alarm relay terminal (C026):
"01" (FA1: constant-speed reached), "02" (FA2: set frequency overreached), "06" (FA3: set frequency
reached), "24" (FA4: set frequency overreached 2), and "25" (FA5: set frequency reached 2)
The hysteresis of each frequency-arrival signal is as follows:
When the signal is on: ("set frequency" - "1% of maximum frequency") (Hz)
When the signal is off: ("set frequency" - "2% of maximum frequency") (Hz)
The signal hysteresis at acceleration with function "06" (FA3) or "25" (FA5) set is as follows:
When the signal is on: ("set frequency" - "1% of maximum frequency") (Hz)
When the signal is off: ("set frequency" + "2% of maximum frequency") (Hz)
The signal hysteresis at deceleration with function "06" (FA3) or "25" (FA5) set is as follows:
When the signal is on: ("set frequency" + "1% of maximum frequency") (Hz)
When the signal is off: ("set frequency" - "2% of maximum frequency") (Hz)
Item
Frequency arrival setting for
accel./Frequency arrival setting
for acceleration (2)
Frequency arrival setting for
decel./Frequency arrival setting
for deceleration (2)
Function code Range of data
C042/C045
0.01 to 400.0 (Hz)
C043/C046
0.01 to 400.0 (Hz)
4 - 62
Chapter 4 Explanation of Functions
Related code
C021 to C025: Terminal [11] to [15] functions
Related code
C021 to C025: Terminal [11] to [15] functions
C042: Frequency arrival setting for accel.
C043: F requency arrival setting for decel.
C045: F requency arrival setting for
acceleration (2)
C046: Frequency arrival setting for
deceleration (2)
0.0 (Hz) Disabling the output of frequency
Enabling the output of frequency
0.0 (Hz) Disabling the output of frequency
Enabling the output of frequency
Description