Brother MFC5490CN Service Manual page 219

(18) Turn the registration sensor actuator in the direction of the arrow shown below and take it
off the inner chute ASSY. The sensor actuator spring comes off.
(19) Take the registration sensor PCB out of the support arms.
Note: The registration sensor PCB and the PF encoder PCB are assembled with their
harnesses. To completely release the registration sensor PCB from the engine unit,
therefore, you need to remove the PF encoder PCB at the next step.
Assembling Note: Before mounting the inner chute on the engine unit, set the registration
sensor actuator and its spring. Also set the registration sensor PCB and route the PF
encoder/registration sensor harness. See the illustration below.
Routing the PF encoder/registration sensor
harness on the inner chute ASSY.
Support arms
Inner chute ASSY
Registration
sensor PCB
Support arms
Actuator support
Hooking the sensor actuator spring
Registration
sensor actuator
Cable guide
PF encoder/registration
sensor harness
Cable guide
Registration sensor actuator
6-69
Sensor actuator spring
Inner chute
ASSY
Sensor actuator spring
(6_81_2)
Confidential