Tube Support Plate And Tube Support Wire - Brother MFC5490CN Service Manual

Tube support plate and tube support wire

(3) Release the four ink supply tubes from the tube support wire.
(4) Pull up the latch and slide the tube support plate to the left, and then take the plate out of
the lower cover together with the tube support wire.
(5) Remove the tube support wire from the tube support plate.
Ink supply tubes
Latch on the bottom of
the tube support plate
Tube support plate
CR encoder
strip support
Assembling Note: After mounting the head cover, set the CR encoder strip so that the
marked end is to the right (carriage motor side) and the mark points upwards as shown
above, using the following steps.
1) Hook the left end of the CR encoder strip on the left-hand strip support, aligning the
rectangular hole provided in the strip with the boss of the strip support.
2) Pass the strip through the CR encoder sensor located on the head/carriage unit by
inserting it into the opening of the head cover from left to right.
3) Hook the right end of the strip while pushing the left-hand strip support inwards.
This should point up.
CR encoder strip
Tube support wire
3
Engine unit
6-46
2
(Front)
Lower cover
1
Hook
(6_56)
Confidential
-