Sensitivity Adjustment Of Registration Mark Sensor And Check Of Belt Surface (Function Code 75) - Brother DCP-9010CN Service Manual

1.4.24 Sensitivity adjustment of registration mark sensor and check of belt
surface (Function code 75)
<Function>
This function makes the registration mark sensor to adjust its sensitivity compulsory. This
allows you to check if the registration mark sensor works properly. This function makes the
machine to check the surface of the belt unit by using the registration mark sensor as well.
<Operating procedure>
(1) Press the 7 and 5 buttons in this order in the initial state of the maintenance mode.
"REGI SENS ADJUST" is displayed on the LCD.
(2) Press the
(3) Press the OK button to execute the selected item.
(4) When the operation is finished, the machine beeps for one second and returns to the
initial state of the maintenance mode.
LCD
REGI_SENS ADJUST
BELT OFF
REGI_SENS ADJUST
BELT ON
REGI_SENS ADJUST
BELT CHECK
Note:
- If you press the OK button during the sensitivity adjustment or after the error message
appears on the LCD, the sensitivity adjustment is started again.
- In the case that the error occurs, refer to the
the way to solve it.
or button to select the appropriate item.
Adjust the sensitivity of the registration mark sensor when the belt
unit is not operated. This is to check whether the registration
mark sensor's operation is okay or not.
Adjust the sensitivity of the registration mark sensor while the belt
unit is driving. (This is the same as the sensitivity adjustment
performed before adjustment of color registration.)
Check that there are no scratches on the surface of the belt unit of
the registration mask sensor.
7-46
Description
next page to check the error description and
Confidential