Brother DCP-9010CN Service Manual page 133

■ Error code 9A
Manual Feed
Load <size> Paper.
No paper in manual feed slot (The manual paper actuator is not turned ON.)
Drum Cleaning
Insert the blank paper into the Manual feed slot.
No paper is inserted on the manual feed slot when drum cleaning is executed.
(The manual paper actuator is not turned ON.)
<User Check>
- Insert a paper into the manual feed slot.
Step
1 Harness connection failure of
manual sensor PCB ASSY
2 Manual sensor failure
3 Registration front/rear sensor
PCB failure
4 HVPS control PCB failure
5 Main PCB failure
■ Error code 9F
No Paper
Load <size> paper, then press Start.
No paper while printing
<User Check>
- Load the paper into the paper tray.
Cause
3-41
Remedy
Check the harness connection of the
manual sensor PCB ASSY and reconnect it.
Check the sensor performance following
the procedure described in
32". If any problem occurs, replace the
manual sensor PCB ASSY.
Replace the registration front/rear sensor
PCB ASSY.
Replace the HVPS control PCB ASSY.
Replace the main PCB ASSY.
"Function code
Confidential