Brother DCP-9010CN Service Manual page 101

Error message
Jam XXX
Low Temperature
Manual Feed
No Belt Unit
No Paper
No Response/
Busy
No Toner
No Waste Toner
Out of Memory
Print Unable ##
Protected Device
(USB direct interface
model only)
Registration
Scroll message:
Registration failed.
See
Troubleshooting
chapter in User's
guide.
Rename the File
(USB direct interface
model only)
Replace Belt
Replace Drum (X)
Replace Drums
or
Replace Toner
Replace WT Box
Replace Fuser
* (X) at the end of the message shows the color of the toner cartridge or drum unit.
(X) must be either K (Black), Y (Yellow), M (Magenta) or C (Cyan).
Description/Measure
Carefully pull out the jammed paper from the area shown
in the message.
Increase room temperature to allow the machine to
operate.
Put the same size of paper in the manual feed slot as is
shown on the LCD. If the machine is "paused", press
Start/Black button.
Install the belt unit.
Put paper in the indicated empty tray. If the problem is
not solved, the paper pick-up roller may be stained.
Clean the paper pick-up roller.
The number you dialed dose not answer.
Install the toner cartridge that is indicated on the LCD.
Install the drum unit that is indicated on the LCD.
Install the waste toner box.
If the LCD shows this error message when you print the
secure data, press Job Cancel button and delete the
previously stored data. Except in the case of printing
secure data, and add more memory.
Turn off the machine. Wait a few seconds and turn it on
again.
The protect switch of the USB flash memory drive is on.
- Turn off the machine. Wait a few seconds and turn it
on again.
- Put in a new belt unit.
There is already a file on the USB flash memory drive
with the same name as the file you are trying to save.
It is time to replace the belt unit. Replace the belt unit.
* It is time to replace the drum unit. Replace the drum unit
that is indicated on the LCD.
It is time to replace the toner cartridge. Replace the
toner cartridge that is indicated on the LCD.
It is time to replace the waste toner box. Replace the
waste toner box.
It is time to replace the fuser unit. Replace the fuser unit.
3-9
Refer to:
3-37
3-38
3-58
---
3-41
3-49
3-40
3-41
3-88
3-96
3-55
3-49
3-47
3-14
I
3-53
3-48
3-56
3-31
3-39
---
3-27
3-23
3-29
3-31
3-50
3-54
3-24
Confidential