Ncu Pcb Assy (Ncu Model Only) - Brother DCP-9010CN Service Manual

8.30 NCU PCB ASSY (NCU model only)

(1) Remove the two Taptite pan (washer) B M4x12 DA screws, and then remove NCU FG
harness ASSY 2 from the NCU shield.
(2) Remove the Screw PAN (S/P washer) M3.5x6 screw, and then remove the NCU FG
harness ASSY 1 from the NCU shield.
(3) Lift the NCU shield from the Joint cover sub ASSY.
Taptite pan (washer) B M4x12 DA
NCU FG harness ASSY 2
(4) Turn the NCU shield upside down.
(5) Remove the two Taptite cup S M3x6 SR screws, and then remove the NCU PCB ASSY
from the NCU shield.
(6) Disconnect the NCU harness ASSY from the NCU PCB ASSY.
NCU PCB ASSY
Harness routing: Refer to
Fig. 5-76
6
5
Fig. 5-77
" NCU Shield."
5-83
Screw PAN (S/P washer) M3.5x6
NCU FG harness ASSY 1
NCU shield
Joint cover sub ASSY
Taptite cup S M3x6 SR
NCU harness ASSY
NCU shield
Confidential