Power On Function; Kb Power On Password; Hot Key Power On; Onboard Fdc Controller - Albatron KX18D PRO User Manual

KX18D Series
OnChip 1394 (only for KX18D PRO II)
This item allows you to enable or disabled the 1394 Device. Options: Enabled (default)、Disabled
Onboard I/O Chip Setup
If you highlight the "Onboard I/O Chip Setup" label and then press the enter key, it will take you to a
submenu with the following options:
PWRON After PWR-Fail
This field will determine whether your system will boot after restoring power after a power failure. If
you select "On", the system will boot whether or not the system was on before power failure. If you
select "Former-Sts", the system will be restored to the status before the power failure.
Options: Off (default)、On、Former-Sts

Power On Function

This field allows you to select a way to power on your computer. Options: Password、Hot KEY、
Mouse Left、Mouse Right、Any KEY、BUTTON ONLY (default), and Keyboard 98

KB Power ON Password

This field allows you to set the password to power on your system. This field is only configurable
when "Power On Function" is set to "Password".

Hot Key Power ON

This field allows you to use the Ctrl key along with a hot key (function key) to power on your system.
This field is only configurable when "Power On Function" is set to "Hot Key".
Options: Ctrl-F1、Ctrl-F2...... Ctrl-F12

Onboard FDC Controller

Select "Enabled" if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add-in FDC or the system has no floppy drive, select "Disabled".
Options: Enabled (default)、Disabled
Onboard Serial Port 1/ Port 2
Select an address and corresponding interrupt for the first/ second serial port. Options: Disabled、
3F8/IRQ4 (default for port1)、2F8/IRQ3(default for port2)、3E8/IRQ4、2E8/IRQ3、Auto

UART Mode Select

This item allows you to select the Infra Red (IR) standard to be used.
Options: Normal (default)、ASKIR、IrDA
36