Front Panel Indicator: Sw/Led、Pwrled、Speaker - Albatron PX915PC PRO-G User Manual

nectors
Floppy Disk Connector: FDC
These mainboards provide a standard floppy disk connector (FDC) that supports 360K, 720K, 1.2M,
1.44M and 2.88M floppy diskette drives. This connector supports the floppy drive ribbon cables
provided in the packaging.
Hard Disk Connectors: IDE1/ SATA1-4
These mainboards provide a standard IDE connector that supports PIO Mode 0~4, Bus Master, Ultra ATA
66/100. 4 Serial ATA connectors are also available and can provide 150 MB/s transmission rates.
IDE1 (Primary IDE Connector)
You can connect 2 IDE devices to the IDE1 connector using a single ribbon cable with 3 connectors (2
for the drives and one to connect to the board). If you are connecting 1 drive, you should configure it
as the Master device. If you are connecting a second drive, you must configure it as the Slave device
(see your hard drive manual for master/slave configuration specifics). If you have an IDE CD-ROM drive,
you just can attach it to this connector.
SATA1-4 (Serial ATA connector)
These SATA connectors (SATA1 – SATA4) support Serial ATA 150. Each SATA connector can only support
one serial ATA device. Note: With most storage devices, there is a power cable that you need attach to
a power source (power supply).
Front
PX915PC/ PX915GC Series
16
Panel