Drive Configuration; Overview; Devicenet Connection Configuration; Control Locations - ABB RDNA-01 User Manual

Drive configuration

Overview

This chapter gives information on configuring the RDNA-01
DeviceNet Adapter module.

DeviceNet connection configuration

The detailed procedure of activating the module for
communication with the drive is dependent on the drive type.
(Normally, a parameter must be adjusted to activate the
communication. See the drive documentation.)
As communication between the drive and the RDNA-01 is
established, several configuration parameters are copied to the
drive. These parameters (shown in
and adjusted if necessary. The alternative selections for these
parameters are discussed in more detail below the table.
Note: The new settings take effect only when the module is
powered up the next time or when the module receives a 'Fieldbus
Adapter parameter refresh' command from the drive.

Control locations

ABB drives can receive control information from multiple sources
including digital inputs, analogue inputs, the drive control panel
and a communication module (e.g. RDNA-01). ABB drives allow
the user to separately determine the source for each type of
control information (Start, Stop, Direction, Reference, Fault Reset,
etc.). In order to give the fieldbus Scanner the most complete
control over the drive, the communication module must be
selected as source for this information. See the user
documentation of the drive for information on the selection
parameters.
Table 1.) must be checked first
Drive configuration
35