Drive Configuration; Overview; Ethernet Connection Configuration - ABB FENA-01 Protocol Manual

Drive configuration

Overview

This chapter gives information on configuring the FENA-01
Ethernet Adapter module for use with Modbus/TCP.

Ethernet connection configuration

After the FENA-01 Ethernet Adapter module has been
mechanically and electrically installed according to the FENA-01
Hardware Manual, the drive must be prepared for communication
with the module.
The detailed procedure of activating the module for Ethernet
communication with the drive is dependent on the drive type.
Normally, a parameter must be adjusted to activate the
communication (see the drive documentation).
As communication between the drive and the FENA-01 is
established, several configuration parameters are copied to the
drive. These parameters
checked first and adjusted where necessary. The alternative
selections for these parameters are discussed in more detail
below the tables.
Note: The new settings take effect only when the module is
powered up the next time or when a 'Fieldbus Adapter parameter
refresh' is given (see the drive documentation).
(Table 1., Table 2. and Table 3.) must be
Drive configuration
13