Installation Instructions - Dish Network 500 Instructions Manual

Chapter 4

Installation Instructions

Azimuth: _________
Elevation: ________
Skew: ___________
Page 84
2. Make sure that the remote control batteries are fresh, and are installed
properly. If needed, make sure that the remote is in SAT mode to
control the satellite receiver.
3. Turn ON the television and receiver.
4. Display the
Point Dish and Signal Strength
MENU and then 6-1-1 (unless the receiver already displays this
menu).
5. If your Point Dish/Signal screen looks like the one on the left,
continue to the next step. If your Point Dish/Signal screen looks like
the one on the right, select
6. Enter your ZIP code in the
7. Select the
Dish 500
8. The menu displays the azimuth, elevation, and skew angles. Write
down these numbers in the blanks provided in the margin.
9. Select to exit out of this menu and return to the
Cancel
menu.
Dish/Signal
10. Go to Mounting the Dish on page 85.
.
Peak Angles
field.
ZIP Code
option.
menu by pressing
Point