Dish Network 500 Instructions Manual page 92

Chapter 4
Installation Instructions
Page 88
shown below. Be sure there are no multi-dish switches between the
LNBF and the receiver.
10. Attach the LNBF to the Y-bracket using the two LNBF screws.
11. Slide the dish assembly down onto the mast. Make sure the pivot bolt
rests on the top of the mast. Turn the dish assembly so that it points in
the general direction of the satellites, using the azimuth angle from
page 84.
12. You should see the
Point Dish/Signal
, select
Menu System Setup
(press MENU, and then press 6-1-1 on the remote).
Signal
13. Select
Check Switch
14. or
Select Check Test
checking the switches. Go to the next step.
15. When the check switch procedure finishes, you will see an installation
summary screen similar to the one below. In the
will see the word "Conn." In the
"Twin" twice. This indicates that your receiver has confirmed the
connection with your DishPro Twin LNBF is working. The
menu. If not, open the
, then
Installation
. The screen will open.
Check Switch
. The receiver shows you a message that it is
line, you will see the word
Device
Main
, then
Point Dish/
line, you
Satellite