Dish Network 500 Instructions Manual page 30

Chapter 2
Parts of the System
Change the Address
Because UHF signals travel long distances and go through walls, a neighbor's
remote could control your receiver by mistake. To prevent this problem, you
can change the address on the remote and receiver as follows;
1. Make sure the TV and receiver are turned on.
2. Open the
3. The
4. Press and hold the SAT button for about three seconds, until
5. Use the number buttons to enter any number from 1 to 16, but
6. Press the POUND (#) button. If you entered the address correctly, the
7. Press the RECORD button.
8. Make sure the
9. To check the address in the remote control, press and hold the SAT mode
Press the SELECT button to close the
screen.
Page 26
Important System Information
pressing the receiver's front panel SYS INFO button.
Important System Information
.
Remote Address
Write down this number:
all of the mode buttons light up, and then let go of the SAT
button.
not the one you wrote in step 3.
Write down the number you enter:
SAT mode button flashes three times.
Remote Address
screen matches what you entered in step 5. If the addresses
Information
are not the same, repeat step 7.
button for about three seconds. Then, let go of the SAT button, and press
the POUND(#) button twice. The SAT mode button flashes the same
number of times as the address you entered in step 5.
menu by
menu shows a
you see on the
Important System
Important System Information