Dish Network 500 Instructions Manual page 80

Chapter 3
Using the System
Use these buttons to change channels on the cable box.
The SELECT button works as the ENTER button for the cable
box.
Press this button to go back to the last cable box channel you used.
Press it again to switch between the last two cable box channels
you used.
Use these buttons to enter channel numbers.
Tip: Some of
the buttons
we tell you
about here Control a Tuner or Amplifier
may not
control your
tuner or
amplifier. Be
sure to check
the user guide
that came
with the
device for full
You must first set up the remote to control the device. Please see Set
details.
Up the Remote to Control Devices, beginning on page 68. Then, you
must press the AUX mode button to set the remote to AUX mode. The AUX
mode button flashes once to show you've set the remote to AUX mode. Make
sure you keep the remote in AUX mode to use the buttons we tell you about
here.
Press the blank POWER button to turn the tuner or amplifier on
or off.
Page 76
Up/Down Arrow Buttons
Select Button
Recall Button
Number Buttons
Only the buttons we tell you about here control a tuner or amplifier.
Some of the buttons we tell you about here may not control your
tuner or amplifier. Please see the user's manual that came with your
tuner or amplifier for more information.
Aux Mode Button
Power Button