Dish Network 500 Instructions Manual page 94

Hide thumbs Also See for 500:
Table of Contents

Advertisement

Chapter 4
Installation Instructions
Page 90
19. You are now ready to verify reception from both satellites. Select the
option.When the
Check Switch
or
. The receiver shows you a message that it is checking
Check
Test
the switches. When the procedure is finished, you will see an
Installation Summary
one shown below. However, you must see that you have signals from
both the
and
110 West
line, and the message "Satellite reception verified.
Transponder
Select CANCEL or OK to exit this menu."
20. If you do not see "110" under
Make sure the skew angle you wrote down on page 84 is exactly
the same as the skew angle you set in step 5 on page 86. If it is
not, reset the skew angle as described on page 86. After you reset
the skew angle, go back to page 89 and start over from step 16.
If "119" is shown under
approximately 9º to the east and restart the procedure at step 12.
21. Look at the
Point Dish/Signal
with the check mark in
If you have good signal strength on
If you do not have good signal strength with the check mark in
, go back to Step 17, and fine-tune the dish but with the check
West
mark in
instead of
110 West
West signals will not be equal, you should be able to fine-tune the
dish until you have the strongest possible signal from both satellites.
22. Select CANCEL to exit the
screen will open asking if the mounting and positioning of your dish is
complete with a "Locked" indication in the Point Dish/Signals screen.
If the answer is yes, select
, you will need to repoint your dish following the
If the answer is
No
preceding step until the mounting and positioning is complete and you
do have the "Locked" indication.
Check Switch
screen. This screen may look different than the
Satellites, you see "All" twice in the
119 West
:
Dish Input 2
, move the dish
Dish Input 2
menu. If you have good signal strength
, move the check mark to
119 West
, go to the next step.
110 West
. While the 110 West and 119
119 West
Point Dish/Signal
.
Yes
menu opens, select
.
110 West
110
menu. An Attention

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

300

Table of Contents