Dish Network 500 Instructions Manual page 66

Chapter 3
Using the System
Press the PAUSE button and then press the FWD button to forward the button
in slow motion. When you press the FWD button once, the program advances
at 1/15 the speed of normal play. Press the FWD button twice to forward at 1/
4 the speed of normal play. Press the FWD button three times to play the
program.
Note:
hasn't been broadcast yet.
Press the PLAY button to watch or to go back to watch the
program. Also, press this button to switch from forward or reverse
back to watch the program as usual.
Press the SKIP BACK button to skip back about ten seconds in the
program. Press this button again to skip back again.
Press the SKIP AHEAD button to skip ahead about 30 seconds in
the program. Press this button again to skip ahead again.
Note:
program that hasn't been broadcast yet.
Press the VIEW button to catch up with the program as it's showing
now.
Use On-Demand Recording
Turn the receiver on and tune it to a channel. Then you can do these things:
Note:
you'll have to enter the password to play back that program.
Start recording a program:
Page 62
Of course, you can't "forward" into the part of a "live" program that
Of course, you can't "forward" into the part of a "live"
If you record a locked program while you have the receiver locked,
At a program's start, press the remote control's RECORD
•
button.
If you've watched a program from its start, up to about one
hour after it's started, do this:
1. Press the BACK button.
2. Let the program reverse to its start.
3. Press the RECORD button.You'll get all
of the program on your recording.
If you don't tune to a program until
Note:
after it starts, you can record only the part of
the program that comes after you tune to it.