Dish Network 500 Instructions Manual page 96

Chapter 4
Installation Instructions
Azimuth: _________
Elevation: ________
Page 92
2. Make sure there is a check mark next to the satellite your dish will be
pointing at.
3. If your
Point Dish/Signal
continue to the next step. If your
the on eon the right, select
4. Select
Peak Angles
5. Use the number buttons on the remote to enter your ZIP code to get
the necessary azimuth and elevation. Write these numbers down in the
spaces provided in the margin.
6. Mount the dish following the mounting instructions that came with it.
7. Connect an RG-6 cable from the DishPro S
receiver directly to the DishPro LNBF on the Dish 300. Make sure
there are no multi-dish switches between the LNBF and the DishPro
receiver.
8. Select
Check Switch
screen opens, select
Check Switch
9. When
Check Switch
screen similar to the one shown next. It will show a
Summary
connection ("Conn" next to satellite) and
Input). It may also show an X on the Transponder line. This is okay
and does not mean there is a problem with the system.
screen looks like the one on the left,
Point Dish/Signal
and the
Peak Angles
.
AT
from the
Point Dish/Signal
.
Check
is complete, you will see an
Single
screen looks like
option.
Dish 300
I connection on the
N
menu. When the
Installation
device under 1 (Dish