Table of Contents
Advertisement
1. Log in to the home page.
2. Click Advanced settings (
3. Click WAN > 4G.
Note: 4G information is not available if WAN Mode is "3G Only or 4G Mode is "LTE Only."
(WAN Mode and 4G Mode are in Advanced settings > WAN > Setup.)
From this window, you can view this 4G information, or perform the following actions:
● Connection Status — This field reflects whether you are connected to 4G.
● Service Type — This field reflects the 4G service type: 4G, 4G Off, power save mode,
or no service.
● Scan for Private Network — Click this link if you have been informed that a private
network might be available to you. (See "Scan for Private Network" in
Panel.)
● RSSI and CINR.
RSSI reflects the signal strength of the network.
CINR stands for Carrier to Interference-plus-Noise Ratio and is a measurement of signal
effectiveness. For the receiver to decode the carrier signal, the latter must be in an
acceptable CINR range.
● TX Power — This number indicates the transmitter power. A higher number is better.
● Center Frequency — This number indicates the frequency of the 4G channel used for
the data connection.
● NSP-ID — This number is the ID of the 4G Network Service Provider.
● NAP-ID — This number is the ID of the 4G Network Access Provider.
● BSID — This number is the ID of the Base Station.
● Preamble — This number is the preamble ID of the current base station that the modem
is listening to.
● Realm — This login address is used for 4G service (user@realm).
● Certificate Information — Click the link to display information in a popup window. You
will be prompted to enter the Service Programming Code (SPC). (If you don't know your
SPC, contact Sprint.)
Device Settings
).
85
WAN Tab: 4G
Advertisement
Table of Contents
