Table of Contents
Advertisement
The WPS feature is available on certain cameras, printers, smartphones, and laptops. These
devices have either a hardware button or a WPS-related option in the software. Please consult
the user documentation of your device.
To turn this feature on or off:
1. Make sure you're logged in to the home page.
2. Click WPS (below the Virtual Device).
3. In the WPS Setup window, select Enable or Disable.
4. Click Save.
WPS is not available in any of these situations:
● Wi-Fi is not enabled. (See
● The Wi-Fi security option is WPA Personal, WEP, or WEP-related (for example, "WEP
64 Bit Open"). (Note: WPS is available if the Wi-Fi security option is WPA/WPA2
Personal.)
● SSID Broadcast is not enabled. (See
● WPS is turned off (from the WPS Setup window).
● MAC filter mode is "Allow all in list", but no computers have been added to the list. (See
"Specifying Computers That Can Access the Network" in
Computers Access to the
If the maximum number of connected devices has already been met, an error message "Max
connected devices" or "Max Wi-Fi users" is displayed when you attempt WPS. Disconnect one
of the connected devices and then retry.
Your Network Connection
Wi-Fi Tab: Network
Wi-Fi Tab: Network
Network.)
35
Panel.)
Panel.)
Allowing or Denying
Advertisement
Table of Contents
