HP Integrity rx2600 Operation And Maintenance Manual page 50

System Configuration
❏
run it from a command-menu interface, or
❏
review the command line help for that command
One example of a multilevel command is the
MP:CM> ca
This command allows you to modify the local and remote modem serial
port configurations. Note that terminal type is set simultaneously
for all ports. At each prompt you may type DEFAULT to set default
configuration or Q to Quit
Local and Remote Serial Port Configuration Menu:
D - Display Local/Remote Serial Port Configuration
L - Modify Local Serial Port Configuration
R - Modify Remote/Modem Serial Port Configuration
T - Modify Terminal type
Enter menu item or [Q] to Quit: q
MP Host Name: gstlhpd6
MP:CM> ca -r default
New Remote/Modem Serial Port Configuration (* modified values):
* Bit Rate in bits/sec
* Flow Control
* Modem Presence
* Modem Protocol
* Transmit Configuration Strings : Enabled
Confirm? (Y/[N]):
In this example, the
◆
All parameters to the default settings, run:
◆
Specific level such as remote or local port configuration to the default, run
-remote default
■
You also can set some parameters to defaults, and others to specified values. For example:
MPcommand -parameter1 value -parameter2 DEFAULT
Command Descriptions
Main Menu Commands
Main Menu commands are run from the following:
❏ iLO MP command prompt with iLO MP firmware E.02.10
❏
Main Menu prompt of the iLO MP interface with iLO MP firmware E.02.20 or higher
Command
CO
VFP
CM
CL
CSP
50
CA
command sets the following:
or
CA -local default
Description
Consoles
Virtual Front Panel
Command Menu
Console Logs
Connect to Service Processor (local/remote ports only)
HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide
CA
serial-port configuration command:
: 19200
: Software
: Always connected
: CCITT
CA -all default
CA