Setting The Initial Power On State - Zektor HDMI5 User Manual

Step 1: Set the HDMI5 to the preferred initial power on state
1 2
Setup the HDMI5 to the initial power on
state you'd prefer. In this case we want the
HDMI5 to turn on and switch to Input 5
when first plugged in.
Step 2: Save the new initial power on state
1 2
1
Start by pressing and
holding the Power
button...
1 HDMI5 Component Video Switch
3 4 5 SEL
3 4 5 SEL
2
...while continuing to hold the Power
button, press and hold the '1' button.
3
After about  seconds, the display will
flash indicating the new power on state
has been accepted.

Setting the Initial Power On State

As long as the HDMI5 is plugged in, it will remember the previously
selec ted input in standby mode. When powered up by pressing the
Power button, it will retur n to that previously selec ted channel.
A1 A2
However, if power is removed (for instance a plug str ip used to
power the HDMI5 is tur ned off ), and then re -applied, the HDMI5's
default behavior is to enter into the standby mode.
I t is possible to change the power on behavior of the HDMI5.
To change the power on defaults...
Step 1: Setup the HDMI5 to your preferred power on state
•
Use the front panel buttons to setup the HDMI5 to the op -
erating settings you'd like at initial power up.
Step 2: Save the new initial power on state.
1. First press and hold the Power button.
2.
While continuing to hold the Power button, press and hold
the '1' button.
3. Af ter holding both buttons for about '' seconds, the dis-
play will blink indicating the new power on defaults have
been accepted.
A1 A2
Test the new initial power on state
•
You can test the new defaults by either disconnec ting the
power supply from the back of the HDMI5 or by unplugging
the power supply from the wall.
•
R econnec t power. The HDMI5 will power up into your new
power on default state.
.
HDMI5 Component Video Switch 1