Easy, Simple, Instructions - Zektor HDMI5 User Manual

Selecting an Input: Press numbered buttons to select an input.
1 2
Audio / Video Breakaway: Press SEL to toggle breakaway options.
1 2
Installing battery (view from back of remote)
 HDMI5 Component Video Switch
3 4 5 SEL
3 4 5 SEL
Only red LED, above
the SEL button is lit,
so only Audio is
switched when
'' is pressed.
2
...while pressing tab,
pull out battery holder.
1
To open: Press small tab
towards center...

Easy, Simple, Instructions!

A1 A2
Initial Setup...
•
Use the HDMI connec tions to switch HDMI signals. Use the
digital audio connec tors to switch digital audio signals,
with automatic conversion bet ween the optical and coax
digital audio for mats.
•
I f using a hardwired IR controller to operate the HDMI5,
connec t the controller IR cable to the IR/Z-IN jack .
•
I f using a PC (or other ser ial controller), connec t it to the
RS -22 jack using a standard ser ial cable.
•
Plug the power module into the HDMI5, and plug the mod-
ule into a standard A.C. wall receptacle. The standby LED
will light up.
Selecting an Input...
•
A1 A2
To switch bet ween any of the five inputs, simply press the
button for the desired input. I f the HDMI5 is in the standby
mode, it will tur n on. The HDMI5 will then switch to the se -
lec ted input, and the associated LEDs will light to indicate
this.
•
To place the HDMI5 back into the standby mode, press and
release the Power Toggle button. The channel LEDs will all
go blank , and the standby LED will light up. Press the Power
Toggle button again to re -selec t the previously selec ted
input.
Audio / Video Breakaway...
•
To break away the audio or video (to listen to the digital au-
dio from one input while viewing video from another) press
the SEL key. When both the RED and BLUE LEDs above the
SEL button are lit, then the audio and video inputs will be
switched simultaneously. When only the RED LED is lit, then
only the Audio will be switched. Similar ly, when only the
BLUE LED is lit, only the video will be switched when press-
ing an input button.
Note: Audio break away only applies to the digital audio con-
nec tions on the back of the HDMI5. You c annot break-
away the HDMI audio channel that is sent over the HDMI
c able. HDMI audio will always follow the video signal.
HDMI5 Component Video Switch 5