Control Functions - Zektor HDMI5 User Manual

Step 1: Place the HDMI5 into the Setup Mode
1 2
Press and hold the Power Button until the
display goes wild. (About  seconds.)
Step 2: Enter the Enable / Disable control state
1 2
After '' is pressed, the standby
LED continues to flash, and the
front panel will display the cur-
rent settings.
Step 3: Enable or Disable control functions
1 2
20 HDMI5 Component Video Switch
3 4 5 SEL
3 4 5 SEL
3 4 5 SEL
Enable/Disable +12V Ctrl.
Enable/Disable IR Control
Enable/Disable Buttons
Enable/Disable IR Jack
Enable/Disable IR Sensor
Exit Setup Mode
A1 A2
I f you are using the rear panel IR jack , you might want to disable the
IR sensors to prevent use of the remote control.
Or if you have a household with young cur ious fingers that likes
playing with buttons, you also have the capabilit y of disabling the
front panel switches and only operating the HDMI5 with a remote.
To enable / disable the front panel switches, and other control
func tions...
Step 1: Enter the Setup Mode
•
The HDMI5 is placed into the setup mode by pressing and
holding the Power button for about  seconds.
Step 2: Enter the Enable / Disable control state
A1 A2
•
While in the setup mode, press '' to enter the Enable/Dis-
able control state. The cur rent status will be displayed us-
ing the front panel LEDs.
•
A Blue LED indicates an option is enabled, and R ed LED
indicates disabled.
Step 3: Enable or Disable control functions
•
Use '1' to enable/disable the IR S ensor hardware.
•
Use '2' to enable/disable the IR Jack hardware.
•
Use '' to enable/disable the front panel buttons.
•
Use '' to enable/disable IR control.
•
Use '5' to enable/disable +12V On/O ff control.
Note 1: The IR Jack and +12V O n/O ff control func tions are mutu-
ally exclusive. Enabling +12V O n/O ff control will disable
A1 A2
the IR Jack hardware. Enabling IR Jack hardware will dis-
able +12V O n/O ff control.
Note 2: When disabling the IR Jack and IR S ensor, the hard-
ware is disabled. Whereas 'IR Control' enables/disables
whether the HDMI5 responds to IR signals received. I f
the IR S ensor or IR Jack are enabled, and 'IR Control'
disabled, IR signals c an still be read through the RS -232
por t, while being ignored by the HDMI5.
Note 3: D isabling the front panel buttons does not disable the
abilit y to enter the S etup Modes.

Control Functions

HDMI5 Component Video Switch 21