Zektor HDMI5 User Manual page 17

Toggle Mode
1 2
All channel LEDs are tur ned off.
Press Pwr Button to
exit setup mode.
Momentary Mode
1 2
All channel LEDs are tur ned off.
Press Pwr Button to
Blue LEDs indicate delay times.
exit setup mode.
0 HDMI5 Component Video Switch
3 4 5 SEL
The blue 'SEL' LED is lit.
D elay Times are ignored.
3 4 5 SEL
The red 'SEL' LED is lit.
A1 = Decrease delay
A2 = Increase delay
Relay Options (Cont'd)
Toggle and Momentary Relay Modes
A1 A2
I f all channel LEDs are off, then the relay will not be affec ted by
changing channels. The 'SEL' button is used to switch bet ween the
Toggle M ode and the M omentar y M ode.
Toggle Mode
I n the Toggle M ode (the blue 'SEL' LED is lit) the relay will toggle
bet ween On and O ff each time the relay button is pressed. All relay
delay times are ignored in the Toggle M ode.
•
Use the 'SEL' button to switch to the Toggle M ode (Blue
'SEL' LED lit).
Momentary Mode
I n the M omentar y M ode (the red 'SEL' LED is lit) the relay will ac -
tivate when it's button is pressed, and then tur n itself off af ter a
programmed amount of time. Use the 'SEL' button to switch to the
M omentar y M ode (the red 'SEL' LED is lit).
•
Use the 'A1' and 'A2' buttons to adjust the amount of time
the relay is ac tive before tur ning itself off. The delay times
are indicated by the top row of blue LEDs and cor respond
to the following times:
No LEDs lit
A1 A2
• One lef t justified LED
•• Two lef t justified LEDs
••• Three lef t justified LEDs
•••• Four lef t justified LEDs
••••• Five LEDs
•••• Four r ight justified LEDs
••• Three r ight justified LEDs
•• Two r ight justified LEDs
• One r ight justified LED
= Same as Toggle M ode
= 1/ seconds
= 1/2 seconds
= 1 seconds
= 5 seconds
= 10 seconds
= 0 seconds
= 1 minute
= 5 minutes
= 10 minutes
HDMI5 Component Video Switch 1