Zektor HDMI5 User Manual page 5

Auxiliary Relay Connections
N/O = Normally Open Contacts. These contacts
are open when the relay's LED is not lit.
COM = Common
N/C = Normally Closed Contacts. These contacts
are closed when the relay's LED is not lit.
Make connections to the adapter which plugs into the HDMI5.
Using the supplied Remote Control
1 2
HDVI5/HDMI5
Use the remote controller buttons in the section
1 2 3 4
labeled: HDMI5 / HDMI5. (The other sections control
5
SEL A1 A2
other Zektor products)
MAS7
Each button on the remote corresponds to the
1 2 3
same button on the HDMI5's front panel.
S2 S3
S1 SYN
CVS4
1 2 3 4
SAS6x2
6 HDMI5 Component Video Switch
1 2 3
Position the clamp as shown
1
and lightly tighten the screw.
Plug in HDMI cable and use
2
wire tie, as shown, to hold
cable in position.
Fully tighten down screw to
3
hold clamp in place.
To remove, or reposition HDMI
4
cable, unscrew clamp, leaving
wire tie in place.
3 4 5 SEL
Auxiliary Relay Connections
•
The auxiliar y relay contac ts are rated for 0volts @ 5amps,
A.C. or D.C., and can be used to switch on and off anything
you can think of within those limits.
•
Each relay has a Nor mally Open connec tion, t wo Common
connec tions, and a Nor mally Closed connec tion.
•
The diagram to the lef t demonstrates the inter nal connec -
tions to the relays.
•
B y using the supplied adapter, the relays connec tions can
be made before rack mounting the HDMI5.
•
The A1 and A2 buttons are used to toggle on and off the
relays.
•
The relays can also be setup to tur n off af ter a given
amount of time. Or to tur n on whenever specified channels
are selec ted. S ee the sec tion "Auxiliar y Relay O ptions" for
relay setup infor mation.
Using the Secure HDMI™ brackets
•
Star t by attaching the bracket to the back of the HDMI5
using one of the supplied screws. Tighten the screw just
enough to keep the bracket securely against the back of
the HDMI5, but still allow free movement.
•
Plug in the HDMI cable. Since the bracket is free to move
you can adjust it to fit any size connec tor. Use a wire tie to
hold the bracket against the cable.
•
Once the wire tie is in place you can tighten the screw to
securely hold the bracket and HDMI cable in place.
•
I f you need to temporar ily remove the HDMI cable, or posi-
A1 A2
tion it to another input, simply unscrew the bracket from
the back of the HDMI, there is no need to remove the wire
tie.
•
M ore wire ties can be purchased at most elec tronic and
hardware stores.
Using the supplied Remote Control
•
I nstall batter y using the diagram on the previous page.
•
Use the sec tion of the remote controlled labeled: HDMI5/
HDVI5 for controlling the HDMI5. ( The other sec tions are
used to control other Zektor produc ts).
•
Each button on the remote func tions the same as the front
panel switch with the same name.
Instructions (Cont'd)
HDMI5 Component Video Switch 7