Using A Different Remote - Zektor HDMI5 User Manual

Step 1: Put the HDMI5 into the Setup Mode
1 2
Press and hold the Power Button for  secs.
The front panel LEDs will start to blink
wildly... (You'll know it when it happens!)
Step 2: Press the '1' button for Intelligent-IR™ learning
1 2
Once the 1 button is pressed, the
Step 3: Teach the HDMI5 its new IR codes
1 2
Press the following sequence of buttons on
POWER
your remote control:
1 2 3
4 5 6
Power 1 2 3 4 5 0 8 9
7 8 9
0
+ + That's it! The HDMI5 now operates with
_ _
VOL CH
 HDMI5 Component Video Switch
3 4 5 SEL
3 4 5 SEL
standby LED will flash slower, and
all the other LEDs will turn off.
3 4 5 SEL
your new remote control!

Using a Different Remote

A1 A2
The HDMI5 features Zektor 's Exclusive I ntelligent-IR™, and with ver y
few exceptions can be setup to use any remote you can point at it!
This is useful if you have more than one HDMI5 in the same room.
Pick a new remote
•
Star t by pick ing a new remote you'd like to use with the
HDMI5. (Or use the unused buttons on the HDMI5's remote.)
•
I f you plan on using a universal remote, star t by setting
it up as a remote for a T V or VCR that you don' t own. (For
instance if you don't own a S ony T V, setup your universal
remote to control a S ony T V.)
Step 1: Put the HDMI5 into the Setup Mode
•
The HDMI5 is placed into the setup mode by pressing and
A1 A2
holding the Power button for about  seconds.
Step 2: Select the Intelligent-IR™ Learn Mode
•
S elec t the I ntelligent-IR™ Lear n M ode pressing '1'.
•
Once the '1' button is pressed, the standby LED will flash
slower and all the other LEDs will tur n off. The HDMI5 is
now waiting for new IR codes to be sent from your remote
control.
Step 3: Teach the HDMI5 your new remote control codes
•
On your remote control, press the following buttons, in the
following order :
Power 1 2 3 4 5 0 8 9
•
The front panel LED's will sequence as each button is
pressed, and the IR LED will flash for each button -- if not,
A1 A2 see the following sec tion on "More Remote O ptions".
•
That 's it! The HDMI5 will retur n to the state it was in before
setup, and will now wor k with your new remote!
The new control buttons on your remote are...
Power
1 - 5
0
8
9
Note: All remote control codes are saved in non-volatile
memor y and will not be lost during a power failure.
Toggles the HDMI5's power.
S elec ts inputs 1 through 5.
S equences the SEL button (A/V break away).
Toggles Auxiliar y R elay 1.
Toggles Auxiliar y R elay 2.
HDMI5 Component Video Switch