Setting The Initial Power On State - Zektor CVS4 User Manual

Step 1: Set the CVS4 to the preferred initial power on state
1
Setup the CVS4 to the
initial power on state
you'd prefer.
Step 2: Save the new initial power on state
1
1
Start by pressing and
holding the Power
button...
4 CVS4 Component Video Switch
2 3 4
2 3 4
2
...while continuing to hold the Power
button, press and hold the '' button.
3
After about 4 seconds, the display will
flash indicating the new power on state
has been accepted.

Setting the Initial Power On State

As long as the C VS4 is plugged in, it will remember the previously
selec ted input in standby mode. When powered up by pressing the
Power button, it will retur n to that previously selec ted channel.
However, if power is removed (for instance a plug str ip used to pow-
er the C VS4 is tur ned off ), and then re -applied, the C VS4's default
behavior is to enter into the standby mode.
I t is possible to change the power on behavior of the C VS4.
To change the power on defaults...
Step 1: Setup the CVS4 to your preferred power on state
•
Use the front panel buttons to setup the C VS4 to the oper-
ating settings you'd like at initial power up.
Step 2: Save the new initial power on state.
1. First press and hold the Power button.
2.
While continuing to hold the Power button, press and hold
the '' button.
3. Af ter holding both buttons for about '4' seconds, the dis-
play will blink indicating the new power on defaults have
been accepted.
Test the new initial power on state
•
You can test the new defaults by either disconnec ting the
power supply from the back of the C VS4 or by unplugging
the power supply from the wall.
•
R econnec t power. The C VS4 will power up into your new
power on default state.
.
CVS4 Component Video Switch