Zektor HDMI5 User Manual page 18

Channel Control - Steady State
1 2
R ed LEDs indicate inputs that
ac tivate relay.
Press Pwr Button to
exit setup mode.
Channel Control - Momentary
1 2
R ed LEDs indicate inputs that
ac tivate relay.
Press Pwr Button to
exit setup mode.
2 HDMI5 Component Video Switch
3 4 5 SEL
Blue 'SEL' LED is lit.
D elay times indicate how long
a relay takes to tur n off af ter
switching away from an ac tive
input.
A1 = Decrease delay
A2 = Increase delay
3 4 5 SEL
R ed 'SEL' LED is lit.
Delay times indicate how long a
relay stays on when switching to
an active input.
A1 = Decrease delay
A2 = Increase delay
Relay Options (Cont'd)
Channel Control Modes
A1 A2
I f any channel LED is lit, then the relay will tur n on when that chan-
nel is selec ted dur ing nor mal operations. The 'SEL' button is used to
switch bet ween the Steady State M ode, and the M omentar y M ode.
Channel Control - Steady State
I n the Steady State M ode (when blue 'SEL' LED is lit) the relay will
remain on for as long as the HDMI5 is switched to an input that has
been setup to ac tivate the relay. When the HDMI5 is switch to an
non-ac tive channel, the relay will tur n off af ter the delay time indi-
cated by the Blue input selec tion LEDs.
•
Use the 'SEL' button to switch to the Steady State M ode
(the blue 'SEL' LED is lit).
•
Use the I nput S elec t buttons to chose which inputs will
ac tivate the relay.
•
Use the 'A1' and 'A2' buttons to adjust the amount of time
the relay remains ac tive before tur ning itself off. The delay
times are indicated by the top row of blue LEDs and cor re -
spond to the delay times given on the previous page.
Channel Control - Momentary
I n the M omentar y M ode (the blue 'SEL' LED lit) the relay will tur n on
A1 A2
for the amount of time indicated by the Blue input selec tion LEDs,
whenever the HDMI5 is switched to an input that has been setup to
ac tivate the relay.
•
Use the 'SEL' button to switch to the M omentar y M ode (the
red 'SEL' LED is lit).
•
Use the I nput S elec t buttons to chose which inputs will
ac tivate the relay.
•
Use the 'A1' and 'A2' buttons to adjust the amount of time
the relay is ac tive before tur ning itself off. The delay times
are indicated by the top row of blue LEDs and cor respond
to the following times. (S ee the previous page for relay
times.)
HDMI5 Component Video Switch