Adjusting The Front Panel Intensity - Zektor HDMI5 User Manual

Step 4: Select between Bright and Dim settings: Use SEL button.
1 2
Use the SEL button to toggle between
the BRIGHT and DIM settings.
Step 5: Adjust Front Intensities.
1 2
Use A1 and A2 to dim and brighten LEDs
A1 = Dim LEDs.
A2 = Brighten LEDs.
Step 6: Use the Power Button to Exit.
1 2
When things look good, press the
power button to exit the setup mode.
16 HDMI5 Component Video Switch
3 4 5 SEL
3 4 5 SEL
3 4 5 SEL

Adjusting the Front Panel Intensity

A1 A2
Continued from previous page...
I f you have not already done so, per for m Steps 1 and 2 on the previ-
ous page.
Step 4: Toggle between Bright and Dim Settings
•
The 'SEL' LED indicates the front panel intensit y settings:
I f BLUE LED is lit, then the BRIGHT level is being adjusted.
I f RED LED is lit, then the DIM level is being adjusted.
•
Use the 'SEL' button to toggle bet ween br ight and dim
settings.
Step 5: Adjust Front Panel Intensities
•
A1 A2
Use the 'A1' button to decrease the intensit y of the front
panel lights.
•
Use the 'A2' button to increase the intensit y of the front
panel lights.
•
You cannot make the DIM level br ighter than the BRIGHT
level, and you cannot make the BRIGHT level dimmer than
the DIM level.
Step 6: Use the Power Button to Exit
•
Once the front panel intensities are acceptable, press the
Power button to save the new settings and exit the setup
mode.
A1 A2
Note: The new intensit y settings are saved in non-volatile
memor y and are not affec ted by a power failure.
HDMI5 Component Video Switch 17