Learning New Discrete Ir Codes - Zektor HDMI5 User Manual

Step 1: Put the HDMI5 into the Setup Mode
1 2
Press and hold the Power Button for  secs.
The front panel LEDs will start to blink wildly.
Step 2: Press the '2' button for Intelligent-IR™ learning
1 2
Once the 2 button is pressed, the
Step 3: Teach the HDMI5 its new IR codes
1 2
Press the buttons on your
POWER
remote, that you want to
1 2 3
use as the new discrete IR
4 5 6
codes, in the order given
7 8 9
in "Step " of the text.
0
+ +
_ _
VOL CH
12 HDMI5 Component Video Switch
3 4 5 SEL
3 4 5 SEL
HDMI5 will be ready to learn new
discrete IR codes starting with
"Discrete Power On".
3 4 5 SEL
Disable current
IR code and
skip to next
Skip current IR
code (leave it
unchanged)

Learning New Discrete IR Codes

A1 A2
The HDMI5 allows discrete IR control over all of it's func tions. These
codes can also be reprogrammed as descr ibed here.
Pick a remote
•
Star t by pick ing the remote you'd like to use with the
HDMI5. (Unused buttons on the supplied remote wor k fine.)
Step 1: Put the HDMI5 into the Setup Mode
•
The HDMI5 is placed into the setup mode by pressing and
holding the Power button for about  seconds.
Step 2: Select the Intelligent-IR™ Learn Mode
•
Discrete IR lear ning is selec ted by pressing the '2' button.
•
Once the '2' button is pressed, the standby LED will flash
A1 A2
slower and all the other LEDs will tur n off. The HDMI5 is
now waiting for new IR codes to be sent from your remote
control.
Step 3: Teach the HDMI5 your new discrete IR control codes
•
On your remote control, press the buttons you'd like to use
as discrete IR codes, in the following order :
Power O n
Power O ff
S equence Inputs
No Breakaway
Breakaway Audio
Breakaway Video
Aux Relay 1 O n
Aux Relay 1 O ff
A1 A2
Aux Relay 2 O n
Aux Relay 2 O ff
•
The new codes are lear ned in the above order, for instance
the first button you press, on the remote, will be use as the
new discrete "Power On", the second button pressed will be
used as the new "Power O ff ", etc.
•
The 'A1' can be pressed to disable the cur rent IR code.
•
The 'A2' can be pressed to sk ip the cur rent IR code, leaving
it unchanged.
Note: All remote control codes are saved in non-volatile
memor y and will not be lost during a power failure.
- Tur ns On Power
- Tur ns O ff Power
- S equence through inputs
- R esets audio/video break away
- S ets audio break away mode
- S ets video break away mode
- Tur ns on Aux R elay 1
- Tur ns off Aux R elay 1
- Tur ns on Aux R elay 2
- Tur ns off Aux R elay 2
HDMI5 Component Video Switch 1