Setting Power On Defaults; The Dvs5.1 Power On Default Mode; Changing The Dvs5.1 Power On Defaults - Zektor DVS5.1 Owner's Manual

Setting Power On Defaults

The DVS5.1 power on default mode

When toggling between Standby mode and PowerOn, the DVS5.1 will remember all it's current set-
tings. After completely powering down the DVS5.1 (by unplugging the AC wall adapter), upon re-
storing power (by plugging the AC wall adapter back in), it will power up in a user settable default
mode. This is useful in situations where the DVS5.1 is externally switched by a power strip.
The factory default settings for initial power on are:
• Initially power up in Standby mode.
• Input 1 will be selected when P
• Auto-dimming mode selected.

Changing the DVS5.1 power on defaults

Teaching the DVS5.1 new power on default settings consists of placing the DVS5.1 in the preferred
initial power on mode, and pressing and releasing the SETUP button on the back panel of the
DVS5.1.
S 1
TEP
ZEKTOR
1 2 3
S 2
TEP
ZEKTOR 1 2 3
S 3
TEP
ZEKTOR
1 2 3
S 4
TEP
ZEKTOR 1 2 3
or
ZEKTOR 1 2 3
OWER
1 Select an initial power on input.
4 5 Audio
Using the S
keys, choose the desired power on default input.
2 Select the initial Bright / Dim / Auto-dimming mode.
4 5 Audio
Using the S
Bright / Dim / Auto-dimming mode.
3 Select the initial power mode, Standby or Powered on.
4 5 Audio
Using the P
the initial power on mode.
4 Press and release the SETUP button located on the back panel of
the DVS5.1. The power indicator light on the DVS5.1 will blink once
4 5 Audio
to indicate the new power on settings have been saved.
The previous picture shows the default power up mode, as being
set to the standby mode. It may also be set to the power on mode,
4 5 Audio
by pressing and releasing the setup key while power is on, as
shown here.
button pressed.
T
OGGLE
1 - S
I
ELECT N ELECT
key, choose the desired power on default
D M
ET IM ODE
, P
T
OWER OGGLE OWER
14
5 keys, or the S
I
N ELECT
ON or P OFF keys, choose
OWER
+ or S
-
ELECT