Setting The Initial Power On State - Zektor HDS4.1 User Manual

Step 1: Set the HDS4.1 to the preferred initial power on state
ZEKT O R 1
Setup the HDS4. to
the initial power on
state you'd prefer.
Step 2: Save the new initial power on state
Z E K T O R 1
1
Start by pressing and
holding the Power
button...
2 HDS4.1 Component Video Switch
2 3 4
2 3 4
2
...while continuing to hold the Power
button, press and hold the '' button.
3
After about 4 seconds, the display will
flash indicating the new power on state
has been accepted.

Setting the Initial Power On State

As long as the HDS4. is plugged in, it will remember the previously
selec ted input in standby mode. When powered up by pressing the
Power button, it will retur n to that previously selec ted channel.
However, if power is removed (for instance a plug str ip used to
power the HDS4. is tur ned off ), and then re -applied, the HDS4.'s
default behavior is to enter into the standby mode.
I t is possible to change the power on behavior of the HDS4..
To change the power on defaults...
Step 1: Setup the HDS4.1 to your preferred power on state
•
Use the front panel buttons to setup the HDS4. to the op -
erating settings you'd like at initial power up.
Step 2: Save the new initial power on state.
1. First press and hold the Power button.
2.
While continuing to hold the Power button, press and hold
the '' button.
3. Af ter holding both buttons for about '4' seconds, the dis-
play will blink indicating the new power on defaults have
been accepted.
Test the new initial power on state
•
You can test the new defaults by either disconnec ting the
power supply from the back of the HDS4. or by unplug-
ging the power supply from the wall.
•
R econnec t power. The HDS4. will power up into your new
power on default state.
.
HDS4.1 Component Video Switch