Changing Switching Delays - Zektor HDMI5 User Manual

Step 1: Place the HDMI5 into the Setup Mode
1 2
Press and hold the Power Button until the
display goes wild. (About  seconds.)
Step 2: Enter the Switching Delay Setup Mode.
1 2
After pressing '5' , the standby
LED continues to flash, and the
front panel will display the cur-
rent delay settings.
Step 3: Adjust Switching Delay Times
1 2
Toggle between audio
and video delays
Decrease delay
Exit setup mode
22 HDMI5 Component Video Switch
3 4 5 SEL
3 4 5 SEL
3 4 5 SEL
Increase delay

Changing Switching Delays

A1 A2
The HDMI5 allows adjusting the its "Mute D elay" times, for Video
and Audio, independently. The "Mute D elay" is the amount of time
the HDMI5 mutes the output when switching inputs. For instance a
"Mute D elay" of 100ms causes the switch to mute its output 100ms
before switching to the new input. B y default the HDMI5 uses a
200ms video and audio delay when switching bet ween channels.
To adjust the Audio/Video mute delays...
Step 1: Place the HDMI5 into the Setup Mode
•
The HDMI5 is placed into the setup mode by pressing and
holding the Power button for about  seconds.
Step 2: Enter the Switching Delay Setup Mode
•
Press the '5' button to enter the D elay S etup M ode.
A1 A2
•
The blue LEDs indicate the video mute delay time, if there
are no blue LEDs lit, then there is no video delay.
•
The red LEDs indicate the audio mute delay time, if there
are no red LEDs lit, then there is no audio delay.
No LEDs lit
• One lef t justified LED
•• Two lef t justified LEDs
••• Three lef t justified LEDs
•••• Four lef t justified LEDs
••••• Five LEDs
•••• Four r ight justified LEDs
••• Three r ight justified LEDs
A1 A2
•• Two r ight justified LEDs
• One r ight justified LED
Step 3: Adjust Switching Delay Times
•
The 'SEL' button toggles bet ween the video and audio delay
settings.
•
The 'A1' and 'A2' buttons are used to set the delay times.
'A1' decreases the delay time.
'A2' increases the delay time.
Press the Power button to save new settings and exit.
Note: The new settings are saved in non-volatile memor y.
= No delay.
= 50ms delay.
= 100ms delay.
= 200ms delay.
= 00ms delay.
= 500ms delay.
= 1 sec delay.
= 2 sec delay.
=  sec delay.
=  sec delay.
HDMI5 Component Video Switch 2