Chapter 8 Lacp Commands; Lacp System-Priority; Lacp (Interface) - TP-Link JetStream TL-SL3428 Cli Reference Manual

Chapter 8
LACP (Link Aggregation Control Protocol) is defined in IEEE802.3ad and enables the dynamic link
aggregation and disaggregation by exchanging LACP packets with its partner. The switch can
dynamically group similarly configured ports into a single logical link, which will highly extend the
bandwidth and flexibly balance the load.

lacp system-priority

Description
The lacp system-priority command is used to set global lacp system priority.
Syntax
Lacp system-priority value
Command Mode
Global Configuration Mode
Parameter
value —— system-priority, ranging from 0 to 65535. By default, the value is
32768.
Example
Set global lacp system priority 1024:
TP-LINK(config)# lacp system-priority 1024

lacp (interface)

Description
The lacp(interface) command is used to enable LACP protocol on the current
port. To disable LACP protocol, please use no lacp command.
Syntax
lacp
no lacp
Command Mode
TL-SL3428
LACP Commands
JetStream L2 Managed Switch CLI Guide
37