Dot1X Port-Method - TP-Link JetStream TL-SL3428 Cli Reference Manual

please use no dot1x port-control command.
Syntax
dot1x port-control { auto | authorized-force | unauthorized-force }
no dot1x port-control
Parameter
auto | authorized-force | unauthorized-force —— The Control Mode for the port.
Auto: In this mode, the port will normally work only after passing the 802.1X
Authentication.
Authorized-force: In this mode, the port can work normally without passing the
802.1X Authentication.
Unauthorized-force: In this mode, the port is forbidden working for its fixed
unauthorized status.
By default, the Control Mode is auto.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Configure the Control Mode for port 1 as authorized-force:
TP-LINK(config)# interface ethernet 1
TP-LINK(config-if)# dot1x port-control authorized-force

dot1x port-method

Description
The dot1x port-method command is used to configure the Control Type of
IEEE 802.1X for the specified port. To restore to the default configuration,
please use no dot1x port-method command.
Syntax
dot1x port-method { mac-based | port-based }
no dot1x port-method
Parameter
mac-based | port-based ——The Control Type for the port.
Mac-based: Any client connected to the port should pass the 802.1X
TL-SL3428 JetStream L2 Managed Switch CLI Guide
71