Igmp-Snooping Static-Entry-Add - TP-Link JetStream TL-SL3428 Cli Reference Manual

member-time —— Member Port Time. Within this time, if the switch does not
receive IGMP report message from the member port, it will consider this port is
not a member port any more. Member Port Time ranges from 60 to 600 in
seconds. By default, it is 260.
leave-time —— Leave Time, which is the interval between the switch receiving
a leave message from a host and the switch removing the host from the
multicast groups. Leave Time ranges from 1 to 30 in seconds. By default, it is 1.
router-port —— Static Router Port, which is mainly used in the network with
stable topology. It ranges from 1 to 28.
Command Mode
Global Configuration Mode
Example
Enable Multicast VLAN, and configure Router Port Time as 300 seconds,
Member Port Time as 200 seconds, and Leave time as 15 seconds for VLAN 2:
TP-LINK(config)# igmp-snooping multi-vlan-config enable 2 rtime 300
mtime 200 ltime 15

igmp-snooping static-entry-add

Description
The igmp-snooping static-entry-add command is used to create static
multicast IP entry. To delete the corresponding entry, please use no
igmp-snooping static-entry-add command. The multicast groups configured
here are not learned by IGMP Snooping and independent of dynamic multicast
groups and multicast filter. Multicast IP addresses ranges from 224.0.0.0 to
239.255.255.255. The range for receivers to join is from 224.0.1.0 to
239.255.255.255.
Syntax
Igmp-snooping static-entry-add {ip} {vlan-id} {switch-port}
no igmp-snooping static-entry-add {ip} {vlan-id}
Parameter
ip —— The static multicast IP address.
vlan-id —— The VLAN ID of the multicast IP, ranging from 1 to 4094.
switch-port —— The forward port of the multicast group, in the format of
1-3,6,23.
TL-SL3428 JetStream L2 Managed Switch CLI Guide
159