Chapter 9 Lacp Commands; Lacp System-Priority; Lacp Admin-Key - TP-Link JetStream TL-SG3424P Cli Reference Manual

Chapter 9
LACP (Link Aggregation Control Protocol) is defined in IEEE802.3ad and enables the dynamic link
aggregation and disaggregation by exchanging LACP packets with its partner. The switch can
dynamically group similarly configured ports into a single logical link, which will highly extend the
bandwidth and flexibly balance the load.

lacp system-priority

Description
The lacp system-priority command is used to set global lacp system priority..
Syntax
Lacp system-priority value
Command Mode
Global Configuration Mode
Parameter
value —— system-priority, ranging from 0 to 65535. By default, the value is
32768.
Example
Set global lacp system priority 1024:
TP-LINK(config)# lacp system-priority 1024

lacp admin-key

Description
The lacp admin-key command is used to configure the admin key. To restore to
the default value, please use no lacp admin-key command.
Syntax
lacp admin-key value
no lacp admin-key
Parameter
value —— admin key, ranging from 0 to 65535. By default, the value is 1.
LACP Commands
38