Connecting To External Usb Hard Disk; Starting Up For The First Time; Language Selection; Terrestrial Settings - Strong SRT 8300 CI User Manual

Digital high definition terrestrial receiver

Table of Contents

3.5 Connecting to external USB Hard disk

Switch on your external HDD (connect the power adapter if applicable) before you connect the USB

connector at the back of your receiver. After ﬁnishing the First Installation (Cap. 4.0) proceed with

following steps:

1. Unless the USB-Hard disk is already formatted in FAT32 and recognised successfully for the ﬁrst

time you will get a message to format your device to FAT32 in "Application" > "USB" menu.

2. In this menu press the YELLOW (Format) button on your remote control to conﬁrm.

After ~10 to 20 sec. (depends on HDD size) formatting will be ﬁnished and you can leave the

menu with the MENU or EXIT button.

3. Go to "Application" >"PDR" menu to adjust the preferred recording duration and set

Timeshift to OFF or ON as desired.

IMPORTANT: During formatting all data on the hard disk will be deleted and get permanently

Ensure that your receiver is correctly connected to your television and terrestrial antenna. Make sure

terrestrial signals are of good quality. Ask your local STRONG dealer to check your terrestrial installation

or signal if you are not sure how to do this.

Conﬁrm that the power plug of receiver is plugged into the wall outlet. Turn on the receiver by power

switch on rear panel. The language section menu will be showing on your TV Screen. It is recommended

that you do ﬁrst time installation following Installation Wizard step by step. It will help you easily achieve

system conﬁguration and channel installation.

If you are advanced user then you can skip wizard by pressing EXIT button and set-up channels using

Installation menu.

Press OK to choose the language.

Select your "Country", "Antenna Supply" and "Channel Numbering" mode. Use pq buttons to select an

item and tu buttons to change the value of the item. With OK you can open the list to select your home

country. To continue installation press BLUE (Save & Exit) button.

At the next step of installation wizard you can adjust your terrestrial antenna for best reception condition.

Please, use tu buttons select channel number where digital terrestrial signal is available and adjust

lost. STRONG cannot be granted for any loss or damage of data, if you format the

hard disk.

PART 1 • English

Table of Contents