Timer - Strong SRT 8300 CI User Manual

PART 1 • English
WARNING: If you have selected RGB mode then HDMI (digital) and YPbPr (component) outputs
on the receiver would be disabled!
Brightness / Contrast / Saturation
n
Use pqtu buttons to select the item and press OK button to display the list of options,
use pq buttons to select level of Brightness / Contrast / Saturation then press OK button to
confirm selection.
5.3.3 Time Setting
To synchronise time in your receiver with broadcaster: set GMT usage to ON, select your time zone and
set Summer time accordingly to season.
In some cases it is recommended to set GMT usage to OFF and setup date/time manually.
5.3.4 Parental Control
In this menu, you can set menu lock status (Disabled or Enabled) and change the PIN code. Parental
rate menu allows you to block watching content which is rated for age equal or higher then you have
set in this menu. Function of this feature depends from broadcast and STRONG would not take any
responsibility if it doesn't work. The default PIN code is 0000.
5.3.5 System Information
Displays the information about software version installed in the receiver.
5.3.6 Factory Reset
Use Factory Reset only when you want to return the receiver to the condition of factory default. This will
delete all user settings and installed channels.

5.4 Timer

You can set the timer to make the receiver perform designated actions including timer based wake up or
sleep instructions to the receiver.
Timer Index
n
Use the tu buttons to select.
Active
n
Use tu buttons to select among Power on, Power off, Duration, Recording and OFF
(disable timer)
Mode
n
You can set the cycle of the action designated in the timer mode (Once, Daily or Weekly)
Channel Type
n
Press OK button to display current channel list and using navigation buttons select channel to
be shown when the receiver will power on by timer event. You can use TV/R button to select
between TV and Radio channels.
15