Text Messages To A Pabx; Errors When Sending And Receiving A Text Message - Siemens Gigaset C200 Instructions Manual

SMS (Text Messages)
Text messages
You can only receive a text message when the Calling Line Identification is for-
warded to the extension of the PABX (CLIP).
The CLIP of the number of the SMS centre is evaluated in the Gigaset (telephone).
If your phone is connected to a PABX, you may have to prefix the number of the SMS
centre with an access code (this depends on your PABX). If in doubt, you can test your
PABX by sending a text message to your own number and putting the access code
before the number of the SMS centre. If you do not receive the message, send another
one, this time without the access code.
When you send messages, your sender number may be sent without your extension
number. The recipient cannot reply to you directly in this case.
Text messages can only be sent and received through ISDN exchanges with the MSN
number assigned to your base.

Errors when sending and receiving a text message

Errors when sending a text message
The following error codes are displayed:
Error Code Description
E0 Calling Line Identification permanently withheld (CLIR).
Calling Line Identification is not enabled.
FE Error occurred during message transfer.
FD Connection to SMS centre failed.
Text messages cannot be sent or received if the number of an SMS cen-
tre is missing or incorrectly stored. Check that the number of the SMS
centre has been correctly stored.
56
to a PABX