Connecting the base to a PABX
The following settings are only needed when your PABX requires them, please refer to
the operating instructions for your PABX.
You cannot send or receive text messages on PABX's that do not support
i
Calling Line Identification.
Dialling modes and recall
The current setting is indicated by
Step 1: Changing the dialling mode
The following dialling modes can be set:
Tone dialling (DTMF),
N
Dial pulsing (DP),
N
DTMF earth (country-specific).
N
[_______________]
MENU
[__________] [_____________________________________________________________]
Base Settings
[__________] [_____________________________________________________________]
Additional Features
[_____________________________________________________________] [__________]
Dialling Mode
[__________] [_________]
OK
Step 2: Setting the recall
[_______________]
MENU
[__________] [_____________________________________________________________]
Base Settings
[__________] [_____________________________________________________________]
Additional Features
[__________] [_____________________________________________________________]
Recall
[__________] [_________]
OK
‰
.
Press the display key to open the menu.
Select the menu item and confirm.
[_________]
OK
Select the menu item and confirm.
[_________]
OK
Confirm.
OK
Select the dialling mode and confirm.
Long press (back to idle status).
Press the display key to open the menu.
Select the menu item and confirm.
[_________]
OK
Select the menu item and confirm.
[_________]
OK
Select the menu item and confirm.
[_________]
OK
Select recall and confirm.
Long press (back to idle status).
Connecting the base to a PABX
99