Appendix; Care; Contact With Liquid; Questions And Answers - Siemens Gigaset C200 Instructions Manual

Appendix

Care

Wipe the base and handset with a damp cloth (use no solvent) or an antistatic cloth.
Never use a dry cloth as this can cause static discharge.

Contact with liquid

If the handset should come into contact with liquid, on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.

Questions and Answers

If you have any questions about the use of your phone, you can contact us 24/7 at
www.my-siemens.com. You will find the most frequently asked questions and answers
below.
What has happened
when ...
... the display is blank?
... the handset fails to respond
to a key press?
... "Base x" flashes in the dis-
play?
... Searching for Base
flashes in the display?
... an internet address appears
in the display?
... (when using more than one
handset) the handset that is in
the base does not charge?
!
Possible Cause
The handset is not switched on.
The batteries are flat.
The keypad lock is activated.
The handset is outside the range
of the base.
The base is not switched on.
The handset is set for Best Base
but no base is switched on or
within range.
The automatic registration of
your handset to the base has
been interrupted.
The base will not charge the
handset if telephoning is simul-
taneously in progress.
Appendix
Possible solution
a
Press the 'end call' key
around 2 sec. .
Charge or replace the batteries
(page 10).
R
Press the hash key
around 2 sec. to deactivate
the lock. (page 11).
Move the handset nearer to the
base.
Check the power connector at
the base (page 8).
Move the handset nearer to the
base.
Check the power connector at
the base (page 8).
Register your handset manu-
ally (page 74).
Use an additional charger.
for
for
101