Checking The Base Station Mac Address; Operating The Base Station On The Pabx; Changing The Dialing Mode; Setting Flash - Siemens Gigaset S675 IP Manual

Operating the base station on the PABX

Checking the base station MAC address

Depending on your network configuration, you may have to enter your base
station MAC address, for example, into your router's access Control list. You can
check your base station MAC address:
v N 5 O M 5
The base station MAC address is displayed.
a
ú For information on how to check your MAC address on the Web configurator,
£
Page
Operating the base station on the PABX
The following settings are only necessary when your PABX requires them; see
the PABX user guide. The settings only concern fixed line network connections.

Changing the dialing mode

You can set the dialing mode.
¢
v Ð
Tone / Pulse
a
Please note
u
Suffix dialing (to select the connection) is not possible in pulse dialing
mode:
A pound "#" is displayed when dialing, but is ignored when pulse dialing.
u
Enter an asterisk "*" to switch temporarily to tone dialing. The asterisk is not
displayed.

Setting Flash

You can set the Flash option.
¢
v Ð
q
The current setting is indicated by
a
142
Press and hold (idle status).
190.
¢ ¢
Telephony Fixed Line
Select and press
Press and hold (idle status).
¢ ¢
Telephony Fixed Line
Select Flash and press
Press and hold (idle status).
¢
Dialing Mode
‰
( = on).
§OK§
¢
Flash
.
§OK§
‰
.