Table of Contents
Advertisement
REMOTE CONTROL OPERATION
LOADING BATTERIES
1. Open the battery compartment cover on the rear of the remote
control unit. The cover should open easily if you slide it in the
direction of the arrow while pressing on it with your thumb.
2. Take out the four supplied alkali (LRO3/AM-4) batteries, and insert
them
into the battery compartment
in accordance
with the
indications in the compartment.
3. Close the cover of the battery compartment.
Cover
Reset button
Incorrect use of batteries may lead to leakage or rupture.
Always be sure to follow these guidelines:
A.
Always insert batteries into the battery compartment correctly matching
the positive
+
and negative
—
polarities, as indicated inside the
compartment.
B.
Never mix new and used batteries.
Cc.
Batteries of the same size may have different voltages, depending on
their type. Do not mix different type of batteries,
20
<ARB1177>
RANGE OF REMOTE CONTROL
When operating the remote control unit, point the front of the unit at
the front panel of the VSA-1000. The remote control unit may be used
within a range of about 7 meters (23 feet) from the remote sensor,
within angles of up to about 30 degrees.
(sf?
Fr
Battery Replacement
When the batteries have run out, the transmit indicator will not illuminate
even when a key is pressed. Be sure to replace the batteries as soon
as possible. As the programmed functions will be retained in memory
only as long as batteries are inserted, remove the old batteries only if
they can be replaced by new ones immediately.
Also, be sure to always use the specified batteries (LRO3/AM-4 alkaline
batteries).
NOTE:
When no batteries are inserted, the programmed memory contents will
be erased after approx.
15 minutes,
7 m (23 feet)
D)
Advertisement
Table of Contents
